Technical Specifications

• Rigid, bend resistant and torsionally stiff, bolted steel block body including all steel transmission components helical geared servomotor mounted with shrink disc-hollow output shaft
• High precision straightener-feeders are built using high quality hardened and ground, alloyed steel straightening and feeding rollers.
• Back-up roller for wide barrel length
• For gap adjustments, top non driven straightening rollers are either separately or totaly adjusted using a worm screw-down mechanism by hand wheel or motor.
• Bottom rollers are driven by synchronised gears which are powered by direct coupled geared servomotor to the main feeding roller.
• All rollers are supported with self aligned roller bearings.
• Entry and exit squaring and guiding tables are adjustable for wide range of strip width.
• Entry and exit feeding (pinch) rollers are activated either pneumatic or hydraulic cylinders.
• Motorized height adjustment system

Options:
Lower inlet table with roller conveyor supporting entry peeler
Motorized upper inlet table
Motorized hight adjustment

Straighteners are used to correct curvature of coiled material which may either hinder passage of sheet stock during stamping operation or cause deformed components in production.
Basic method of straightening is to pass strip being uncoiled through a set of rollers giving a reverse curvature to one already present in the coiled material.
EAE straighteners work in the principle of offset mounted set of rollers which are adjustable for varying degrees of curvature.
Roller diameters must match material thickness and strength. To facilitate this set of adjustable rollers functioning as group is used allowing a wide range of sheet stock to be processed using the same machine.
As the number of rollers used increases straightening accuracy also increases.

 Edge Bow Straightener-Feeder